Power System; Heat Dissipation System - D-Link dgs-8000 SERIES Hardware Installation Manual

DGS-8000 Series Hardware Installation Guide

Power system

1.3.4
DGS-8000 series Ethernet switch uses the AC power input. Currently the 8000-1400AC and
8000-2000AC power modules are provided for this switch. The two power modules support
the power management. The management engine of DGS-8000 can read the power
information and realize the flexible and intelligent management for the whole switch's power
through
8000-1400AC/8000-2000AC module are shown below:
AC input:
Rated voltage range: 100~120V~, 200-240V~; 50/60Hz
Maximum voltage range: 90~264V~; 47~63Hz
Maximum output power: 8000-1400AC: 90~176V~ Power:530W
Note

Heat Dissipation System

1.3.5
The operating temperature of DGS-8000 is 0 to 50°C. The thermal design must ensure that
the switch works at such an ambient temperature for high reliability, security, and reparability.
According to the thermal design of DGS-8000, fans are used to induct air for a forced
convection in order to ensure that the equipment works in the specified environment well.
Figure 1-7 and Figure 1-8 show the flow scheme of heat dissipation of DGS-8006/8010,
respectively.
the power management
8000-2000AC: 90~176V~ Power:1080W
DGS-8006/8010 series switch supports the 1+1 redundancy of power supply.
In order to improve the stability and reliability for the overall system's
operation, you are recommended to configure the 1+1 redundancy for the
power module of DGS-8006/8010.
policy. The technical
176~264V~ Power:1400W
176~264V~ Power:2000W
Chapter 1 Product Overview
specifications
11
of