3.15 Installation Verification; Verifying The Cabinet; Verifying The Cables; Verifying The Power Supply - D-Link dgs-8000 SERIES Hardware Installation Manual

DGS-8000 Series Hardware Installation Guide
2. On the both sides of the chassis, fasten the fibers and twisted pairs to the cabinet cable
management ring or cabling chute.
3. For the power cables, you should bind them closely along the bottom of the chassis, in
a straight line wherever possible.

3.15 Installation Verification

Verifying the Cabinet

3.15.1
 Verify if the external power supply matches the distribution panel of the cabinet.
 After installing the equipment, verify if the front/back cabinet doors can be closed.
 Verify that the cabinet has been fastened completely, and does not move or tilt.
 Verify that the equipment has been installed in the cabinet, and all the cables have
been fastened to the cabinet.

Verifying the Cables

3.15.2
 Verify that the fibers and twisted pairs match the ports.
 Verify that the cables have been bound properly.

Verifying the Power Supply

3.15.3
Verify that the power cables are in good contact and comply with the safety

requirements.
Verify that the power module has been fastened onto the equipment with the two

screws on the panel.
Turn on the power switch and verify that the power module can work normally.

Chapter 3 Switch Installation
53