Wireless Lan Configuration - PROLiNK PWH2004 User Manual

®
PROLiNK PWH2004 User Manual
B.4

Wireless LAN Configuration

To allow Wireless Stations to use the Access Point, the Wireless Stations and the Access Point must use the
same settings, as follows:
Mode
SSID (ESSID)
Open
Shared Key
WEP AUTO
WPA-PSK
WPA2-PSK
WPA-PSK
WPA2-PSK
WPA
WPA2
WPA WPA2
802.1x
Revision 1.0 (Aug'09)
The mode must be set to Infrastructure.
The network name must match the value used on the Wireless Router.
Note! The SSID is case sensitive.
If there is no security is enabled on the Wireless Router, the security of each station
should be disabled as well. And, you can connect the Wireless Router without
security, but it is NOT recommended.
By default, WEP on the Wireless Router is disabled.
If WEP remains disabled on the Wireless Router, all stations must have WEP disabled.
If WEP is enabled on the Wireless Router, each station must use the same settings as
the Wireless Router.
WPA-PSK (TKIP/AES)/ WPA2-PSK (TKIP/AES: If one of these securities is enabled on
the Wireless Router. To make a connection, each station must use the same
algorithms and pass phrase as the Wireless Router.
RADIUS Server: RADIUS is an authentication, authorization and accounting client-
server protocol. The client is a Network Access Server that desires to authenticate its
links. The server is a server that has access to a user database with authentication
information. Each station must set up the RADIUS Server's IP address, port and
passwords that provided by your ISP.
53
www.prolink2u.com