Wireless Station Configuration - PROLiNK PWH2004 User Manual

®
PROLiNK PWH2004 User Manual
5.6

Wireless Station Configuration

• This section applies to all wireless stations wishing to use the Wireless Router's access point,
regardless of the operating system that is used on the client.
• To use the Wireless Router, each wireless station must have compatible settings, as following:
Mode
SSID (ESSID)
Open
Shared Key
WEP auto
WPA-PSK
WPA2-PSK
WPA-PSK
WPA2-PSK
WPA
WPA2
WPA WPA2
802.1x
Note:
By default, the Wireless Router will allow 802.11b, 802.11g and 802.11n connections.
Revision 1.0 (Aug'09)
The mode must be set to Infrastructure.
The network name must match the value used on the Wireless Router.
Note! The SSID is case sensitive.
If there is no security is enabled on the Wireless Router, the security of each
station should be disabled as well. And, you can connect the Wireless Router
without security, but it is NOT recommended.
By default, WEP on the Wireless Router is disabled.
If WEP remains disabled on the Wireless Router, all stations must have WEP
disabled.
If WEP is enabled on the Wireless Router, each station must use the same
settings as the Wireless Router.
WPA-PSK (TKIP/AES)/ WPA2-PSK (TKIP/AES)/ WPA-RADIUS (TKIP/AES)/
WPA2 -RADIUS (TKIP/AES): If one of these securities is enabled on the
Wireless Router. To make a connection, each station must use the same
algorithms and pass phrase as the Wireless Router.
RADIUS Server: RADIUS is an authentication, authorization and accounting
client-server protocol. The client is a Network Access Server that desires to
authenticate its links. The server is a server that has access to a user
database with authentication information. Each station must set up the
RADIUS Server's IP address, port and passwords that provided by your ISP.
48
www.prolink2u.com