Panasonic KX-TA1232 Features Manual page 31

: The button is provided on the designated telephones.
(x): Shows the number of buttons only if multiple buttons are provided.
The functions of the listed buttons are described below:
AUTO ANSWER / MUTE: This dual function button is used for extension auto-answer and
microphone mute during a conversation.
AUTO DIAL / STORE: Used for System Speed Dialing and storing program changes.
CO (Central Office line): Can make or receive an outside call or can be re-assigned to a
different CO or to various feature buttons.
CONF (Conference): Used to establish a three-party conference.
FLASH Allows you to disconnect the current call and originate another call without hanging
up (Flash). Sends a flash signal to the Central Office or host PBX to access their features
(External Feature Access).
FWD / DND (Call Forwarding / Do Not Disturb): Used to program Call Forwarding, set Do
Not Disturb.
HOLD: Used to place a call on hold.
INTERCOM: Used to make or receive intercom calls.
MESSAGE: Used to send a message or display current message.
MONITOR: Used for a hands free operation.
PAUSE: Inserts a pause in a speed dial number. With an analog proprietary telephone, it is
used to enter / exit the Programming mode.
PF (Programmable Feature): This flexible button can be programmed to be a One-Touch
Dialing, FWD / DND, SAVE, Account, CONF (Conference) or Voice Mail Transfer button,
as desired.
REDIAL: Used for Last Number Redial.
SAVE: Used to store a dialed telephone number for Saved Number Redial.
SP-PHONE (Speakerphone): Used for a handsfree operation. Pressing the button causes the
telephone to switch between handset and handsfree operation.
TRANSFER: Transfers a call to another extension or external destination.
Conditions
• Certain buttons are equipped with light indicators (LED's) to show line or feature status.
• CO buttons can be classified according to the following three types: Single-CO (S-CO)
button / Group-CO (G-CO) button / Loop-CO (L- CO) button
Programming Guide References
• [005] Flexible CO Button Assignment
Features Guide References
None
Features Guide
General Features
31