M A I N T A I N I N G A N D T R O U B L E S H O O T I N G T H E P M 8 8 0 - GE PM880 User Manual

F e b r u a r y 2 0 0 5
T a b l e 8 - 3 : E r r o r a n d S c r e e n M e s s a g e s ( c o n t . )
E r r o r M e s s a g e
M I S P r o b e ( c o n t . )
These setup val-
ues will be written
to the attached
MIS probe.
No link to the MIS
probe.
A MIS probe
change has been
detected.
Test Equipment Depot - 800.517.8431 - 99 Washington Street Melrose, MA 02176
8 - 2 8
FAX 781.665.0780 - TestEquipmentDepot.com
P r o b l e m
This screen appears
when new setup data
is manually entered
in the Service, MIS
Probe menu.
This screen appears
when trying to write
to a disconnected
MIS probe.
This screen appears
after a probe change.

M a i n t a i n i n g a n d T r o u b l e s h o o t i n g t h e P M 8 8 0

A c t i o n
[F3]
Press (OK) to over-
write existing data. Press-
ing OK overwrites the
setup data (e.g. reference
values) stored in the MIS
probe electronics mod-
ule.
[F2]
Press (Cancel) to
discontinue.
[F3]
Press ( ) to can-
O K
cel all writes. The PM880
will read from the next
connected MIS probe.
During the "No Link"
condition, the Hygro and
Pressure tabs in the Cali-
brate menu are disabled.
These calibration values
are erased until a new
probe is connected.
[F3]
Press (OK) to can-
cel all writes. The PM880
will read data from the
next connected MIS
probe.