Making Probe Connections - GE PM880 User Manual

F e b r u a r y 2 0 0 5
M a k i n g P r o b e C o n n e c t i o n s
Use the following steps to make probe connections:
1. Make sure the PM880 is turned off.
2. Connect the cable to the probe by inserting the bayonet-type
connector onto the probe and twisting the shell clockwise until
it snaps into a locked position.
The connector on the probe cable must be rotated until it
N o t e :
aligns with the pins in the probe connector, before the
cable may be properly inserted into the probe and
secured.
3. Connect the other end of the probe cable to the top of the unit
by aligning the red dot on the cable connector at the 12
o'clock position. See Figure 2-2 below for the connector
location.
Remove the probe cable by pulling back the spring-loaded
N o t e :
sleeve and pulling the cable out of the connector.
T O E N S U R E T H E S A F E O P E R A T I O N O F T H E P M 8 8 0 ,
Y O U M U S T I N S T A L L A N D O P E R A T E I T
A S D E S C R I B E D I N T H I S M A N U A L . I N A D D I T I O N ,
B E S U R E T O F O L L O W A L L A P P L I C A B L E
S A F E T Y C O D E S A N D R E G U L A T I O N S F O R I N S T A L L I N G
E L E C T R I C A L E Q U I P M E N T I N Y O U R A R E A .
2 - 4
Probe Input
F i g u r e 2 - 2 : C o n n e c t i o n L o c a t i o n s
! W A R N I N G !
T a k i n g M e a s u r e m e n t s