909 909004DEC Instruction Manual page 19

Attaching the flexible shaft
WARNING. Never bend the flexible shaft with a radius of
less than 150mm (6") when operating. Please store the
flexible shaft in the designated compartment of the carry
case when not in use.
1. Remove the collet collar (8)
and then loosen the collet
nut (7) by turning them anti-
clockwise (fig. J).
2. Insert the inner cable of the
flexible shaft into the motor
shaft until the stopper does
not permit the shaft to be
inserted any further (fig. K).
3. Use the wrench to tighten
the collet nut (7) by turning
the nut clockwise (fig. L).
4. Thread the flexible shaft
collet cover onto the rotary
tool housing and turn it
clockwise. Finger tighten
only (fig. M).
WARNING.
Never tighten the collet cover with the use of
pliers or a wrench as the thread will strip.
L
Changing the collet and
accessories on the flexible shaft
Note. To change the collet or install a cutter or accessory
into the flexible shaft, follow the same general procedure as
covered earlier under 'Changing accessories'.
WARNING. Do not attempt to loosen the collet nut of the
J
flexible shaft without pulling the spindle lock back as far
as possible. Damage to the
flexible shaft will result.
1. To lock the spindle lock,
pull the lock back as far as
possible.
2. Use the 2-in-1 wrench to
loosen and tighten the collet
nut (fig. N).
K
M
19
N
N
N