Sim Card - Digicom pocket GSM User Manual

PocketGSM

2.2. SIM CARD

Plug-in SIM are supported by PocketGSM.
To prevent damaging or losing information avoid touching the sim gold area.
Attention: Check with your GSM provider if your SIM is enable for data and fax traffic, if not ask him for
this service, he will give you other two numbers (one for data calls and the other for fax calls).
Insert the SIM
Probably the SIM card will be supplied in a card holder compliant with the devices using
the full-size SIM.
1. Remove the SIM carefully from the SIM holder.
2. Turn off Pocket GSM, by disconnecting the power connector.
3. Discover the SIM slot and press on the release pin with a finger or
a pencil.
4. Insert the SIM card into the holder. Be sure the angled corner is top
right.
5. Close the SIM holder and press it up to the end. Do not force the
SIM holder and verify the correct position. .
2.3. CONNECTION TO THE EXTERNAL ANTENNA
To connect the external antenna go on as follows:
1. Turn off your Pocket GSM by disconnecting the power
connector.
2. Connect the SMA male connector to the external antenna of
Pocket GSM, screwing it clockwise.
3. Place the antenna and check there is a good quality signal.
2.2
Installation