Digicom pocket GSM User Manual page 25

PocketGSM
ATZ Load user profile
This command will load a user profile previously saved with the AT&W command.
Command
ATZ
AT%D Automatic dialing with DTR (C108)
This command allows to activate a DATA or VOICE autocall to the number stored in the
first location of the SIM phonebook; or the automatic sending of an SMS stored in the SIM
first location.
The number is dialed when DTR passes from OFF to ON status; the short message is
sent when DTR passes from OFF to ON status.
Command
AT%D0
AT%D1
AT%D1;
AT%D2
Default: AT%D0
AT&C Data Carrier Detect (C109)
This command defines the management of the DCD (C109) on the modem serial port. If
controlled (AT&C1), the DCD ON indicates the connection with a remote device. If forced
(AT&C0) regardless of the status (connected/disconnected), the DCD is always ON.
Note: Data Carrier Detect can be controlled in DATA and FAX modes only.
Command
AT&C0
AT&C1
Default: AT&C1
Possible answers
OK
Possible answers
OK
OK
OK
OK
Possible answers
OK
OK
4.5
AT Commands
Action
Loads the user profile
Action
Function disabled
Enables automatic dialing (DATA)
Enables automatic dialing (VOICE)
Enables automatic sending of the SMS
Action
Data Carrier Detect always ON
Data Carrier Detect is controlled and
follows the connection status