Digicom pocket GSM User Manual page 27

PocketGSM
Command
AT&S0
AT&S1
Default: AT&S1
AT&V Display configuration
Command
AT&V0
AT&V1
AT&V2
AT&W Save current configuration
This command saves the active configuration, in the EEPROM.
Command
AT&W
This commands can be saved with AT&W
E Q
+CLIP +CMEE
+IFC +ILRR
+++ Escape command
By sending the escape sequence, the modem switches from data to command mode. If
the escape sequence is followed by the ATH command, the connection will be ended.
Note: the escape sequence works only with AT+ICF=3,4 (8N1) or =5,1 (7E1)
Command
+++
Possible responses
OK
OK
Possible answers
OK
OK
OK
Possible answers
OK
S0 V
+CMGF +COPS
+IPR +SIDET
Possible answers
OK
4.7
Action
Data Set Ready always ON
Data Set Ready is controlled and
follows the connection status
Action
Displays the current configuration
Displays the stored configuration
Displays the factory configuration
Action
Saves the configuration
&C &D
+CR +CRC
+SPEAKER
Action
Return to command mode
AT Commands
&S +CBST
+CREG +ICF
+VGR +VGT