Digicom pocket GSM User Manual page 13

PocketGSM
3. FUNCTIONAL EXAMPLES
Pocket GSM can be programmed through a set of AT commands for the execution of all its
functionalities.
If you are using a PocketGSM/GPRS, information for the GPRS functionality are present
in "AT Commands" chapter. It is present in the user's manual on Digicom web site.
Here the description of some applications. For the complete AT command set, see the
chapter "AT Commands".
Attention: In the factory configuration the AT commands are managed at 9600bit/s only (the PocketGSM/
GPRS at 115200bit/s only). Before going on with your settings, you must set your terminal emulator
(e.g. HyperTerminal) or your application as follows: 9600,8,N,1 (with PocketGSM/GPRS: 115200,8,N,1)
then you can modify the interface speed with the values included between 300 and 115200bit/s
with the command AT+IPR.
[ For further information see the chapter "AT Commands" present in the user's manual on Digicom
website ]
A) PIN management
B) PocketGSM ready to work
C) Serial cable not completed
D) Data transfer
E) SMS Management (Text mode)
3.1
Functional Examples