Voice Commands - Digicom pocket GSM User Manual

PocketGSM
AT+CPBF Search for a telephone number (knowing the stored text)
This command is used to find a telephone number inside the phonebook, knowing the
associated identifier (e.g. starting with D...).
Command
AT+CPBF=<"text">
AT+CPBP Search for a telephone number (knowing the number)
This command is used to find an identifier associated with a telephone number inside the
phonebook, knowing the number itself.
Command
AT+CPBP=<"number">

4.2.4. VOICE COMMANDS

PocketGSM can call another voice device with the ATD<number>; command:
e.g.ATD0123456789;
When the remote device answers the call, PocketGSM will show the OK message.
For the voice functionality, PocketGSM is equipped with a double-ended audio interface
on RJ6 female connector with the same Pin-out of a standard telephone handset.
The interface can be connected both to a handset and to a loud speaking telephone.
In order to improve the quality of the voice it will be necessary to modify some parameters
to delete the echo, the noise, etc. In this paragraph you can find the commands necessary
to improve the voice quality. To save the configuration use the AT&W command.
Possible answers
+CPBF:
<idx1>,<number>,<type>,<text>
<idx2>,<number>,<type>,<text>
Possible answers
+CPBP:
<idx1>,<number>,<type>,<text>
4.20
AT Commands
Action
Displays the telephone numbers
with the specified <"text"> identifier
Action
Displays the identifier
associated with the specified <"number">