PocketGSM
<n> CLIP Service status in the network (reading only)
0
CLIP Service not available
1
CLIP Service available
2
Service Status: Unknown (no network...)
AT+CLIR
Calling Line Identification restriction (CLI)
This command allows to hide the Calling Line Identification to the remote device.
Note: Independently from the setting of AT+CLIR, it is possible to add an "i" small letter at the end of
the calling string to present the CLI to the remote user (e.g. ATD0123456789i); or the letter "I"
capital letter to hide the CLI (e.g. ADT0123456789I).
Command
AT+CLIR=0
AT+CLIR=1
AT+CLIR=2
AT+CLIR?
AT+CLIR=?
Default: AT+CLIR=0
<n> CLIR Service status in the network (reading only)
0
CLIR Service not available
1
CLIR Service available
2
Service Status: Unknown (no network...)
3
CLIR Service temporary suspended
4
CLIR Service temporary available
AT+CMEE Report Mobile Equipment errors
This command enables the report +CME ERROR: <err> and +CMS ERROR <SMSerr>
with the indication of the error code, instead of a generic answer. (See Appendix A for
error codes).
Possible answers
OK
OK
OK
+CLIR: 0,<n>
+CLIR: (0-2)
4.13
AT Commands
Action
CLI presentation depends on the
CLIR Sevice status.
CLI is not displayed
CLI is displayed
Shows the current settings and CLIR
Service status
Shows the available settings