Table of Contents
Advertisement
For guidance only, depends on initial battery charge.
General Product Care
Simply wipe the base station with a damp cloth or an antistatic wipe.
Never use a dry cloth as this can cause static discharge.
Periodically clean the charge contacts on the handset and base
and charger with a soft cloth.
Troubleshooting Guide
PROBLEMS
CAUSES
Registration not
The battery is not
work.
sufficiently charged.
Handset and base
station were not
prepared for
registration.
No display.
The battery has not
been charged.
No reactions to
The keypad is locked.
keystroke.
No radio
The handset is
connection to the
outside the base
station range.
base station:
blinking!
The handset is not
registered.
The base station does
not work.
Consumer Information
1.
An applicable certification jacks Universal Service
Order Codes (USOC) for the equipment is provided
(i.e., RJ11C) in the packaging with each piece of
approved terminal equipment.
2.
If this equipment causes harm to the telephone network,
the telephone company will notify you in advance that
temporary discontinuance of service may be required.
But if advance notice isn't practical, the telephone
company will notify the customer as soon as possible.
Also, you will be advised of your right to file a
complaint with the FCC if you believe it is necessary.
3.
The telephone company may make changes in its
facilities, equipment, operations or procedures that
could affect the operation of the equipment. If this
happens the telephone company will provide advance
notice in order for you to make necessary
modifications to maintain uninterrupted service.
4.
Please follow instructions for repairing if any (e.g.
battery replacement section); otherwise do not alternate
or repair any parts of device except specified.
5.
Connection to party line service is subject to state tariffs.
Contact the state public utility commission, public
SOLUTIONS
Charge the battery for
14 hours (see Battery
Charging).
Unplug and then plug
in the power adaptor.
Charge the battery or
replace them (see
Battery Charging)
Press
key longer
than 2 seconds.
Move closer to the
base station.
Register the handset
(see Registering
Handset).
Unplug and then plug
the power adaptor to
the power outlet
(220-230V AC / 50
Hz) and the other end
into the power jack on
base bottom.
– 16 –
Advertisement
Table of Contents
