DETEWE opencom 100 Quick Reference Manual page 20

phone number from another exter-
nal telephone, and thus get the
benefit of different tariff zones, for
example. In addition, the number re-
served in the OpenCom 100 can also
be assigned an internal telephone
number, via which the dialling is to
be performed. In the case of remote-
controlled dialling, there is no check
on authorisation and LCR is not used.
Remote-Programmable
Call Forwarding
Configuring the function
Z
(reserved tel. no.)
*Z
(your internal tel. no.)
0
( for ext.)
Deleting the function
Z
(reserved tel. no.)
*Z
(your internal tel. no.)
Using the telephone number re-
served in the OpenCom 100 for re-
mote control, you can configure or
delete Instant call forwarding for
your own telephone number from a
remote location.
This remotely-programmed for-
warding overwrites any other inter-
nally active forwarding. Forwarding
On Busy and After Delay are not af-
fected. Incorrect or non-existent tel-
ephone numbers are rejected. Your
authorisation is checked in the same
way as for forwarding within the
OpenCom 100.
18
Remote-Controlled Functions
Z
(system PIN)
*
Z #
(dest. tel. no.)
Z
(system PIN)
#
A correct entry is confirmed with a
positive acknowledgement signal,
and the external call subsequently
ended.
Note: The procedure is aborted if
there is a pause of longer than ten
seconds between the entry of two
digits.