Error Alerts In Operation Panel - CAB MACH1 Operator's Manual

6 Operation
22
6.2

Error Alerts in Operation Panel

In the event of a problem that prevents normal functioning of the printer, you will see an error message on LED
indicators and hear some beep signals.
Error Light
Color:
• Red
LED Indicator
LED LED
Power Status
Table 2
Flashing Frequency:
• Flashing
• Light On
Type Beeps
Print Head Error
beeps
Print Head Error
Media Error
beeps
Media Error
beeps
File Error
beeps
Error Alerts in Operation Panel
Description
2 x 4 The printing mechanism
is not closed correctly.
High temperature at the
None
print head.
No ribbon is installed and
the printer displays an
error.
2 x 3
The ribbon is finished or
the label supply hub is
not moving.
No paper is detected.
Paper is finished.
2 x 2
Printer feed problem.
The memory is full.
The printer prints the
message "File System
full".
Unable to find file.
2 x 2 The printer prints the
message "File Name Not
Found" .
A file of the same name
already exists. The printer
prints the message
"Duplicate Name".
Solution
Open the print mechanism and
close it again.
Once the print head has cooled
down, the printer switches to
standby mode.
Make sure that the printer is set to
direct thermal printing mode.
Replace the ribbon roll.
Make sure that the label sensor is
positioned correctly. If the sensor
still does not detect the paper, run
the auto-detection function again.
Replace the label roll.
Possible reasons: the print medium
has become trapped around the
rubber roll; the sensor cannot detect
a gap or black mark between the
labels; there is no paper. Please
reset the sensor.
Delete unnecessary data or install
additional memory.
Use the "~X4" command to print all
files. Then check whether the files
exist and whether the names are
correct.
Change the name of the file and try
storing it again.
22