7
Maintenance
Problem
*
The cutter
does not cut off the labels
in a straight line.
*
The cutter
does not cut off the labels
completely.
When using the cutter
labels are not fed through or cut off
incorrectly.
The present sensor
functioning normally.
Table 3
Troubleshooting
i
Note!
If any problems occur that are not described here, please contact your dealer.
Solution
Check whether the label stock is positioned straight.
Check whether the label is more than 0.2 mm thick.
Check whether the cutter has been correctly installed.
*
, the
Check whether the paper guides are functioning correctly.
Check whether there is dust on the present sensor.
*
is not
Check whether the label stock is positioned correctly.
27