Installation - wattstopper PW-100 Installation Instructions Manual

INSTALLATION

TURN THE POWER OFF AT THE CIRCUIT BREAKER
BEFORE INSTALLING THE SENSOR OR WORKING ON THE LOAD.
1. Make sure that the power has been turned OFF at the circuit breaker.
2. Connect wires to the PW flying leads as shown in the
wiring diagram that is appropriate to the PW model and
electrical supply. The ground wire (green) must be
festened to ground for the sensor to work properly.
3. Attach the sensor to the wall box by inserting screws into
the two wide holes on the top and bottom of the attached
metal bracket. Match them up with the
holes in the wall box and tighten.
4. Turn the circuit breaker ON. Wait one
minute, then push the Auto ON/OFF switch
for each load and the lights will turn ON.
There is a delay due to initial power-up of
the sensor that only occurs during
installation.
5. Test and adjust the sensor if necessary.
6. Attach the cover plate.
Neutral
Line Black
Red
Blue
Brown
Ground Green
PW-200 Bi-Level Wiring
Visit our website for FAQs: www.wattstopper.com
WARNING
Neutral
Line
Ground
PW-100 and PW-100-347 Wiring
Neutral
Black
Line 1
Primary
Line 2 Blue
Load
Secondary
Load
Ground Green
Neutral
PW-200 Dual Circuit Wiring
!
#12 – #14 AWG
Strip Gage
1/2"
12.7mm
Cu Wire Only
Load
Black Red
Green
Red Primary
Load
Secondary
Brown
Load