Mount The Wall Brackets; Attach The System Telephone To The Wall - BinTec elmeg S560 Manual

bintec elmeg GmbH
Wall bracket
Telephone side of the wall bracket
Wall side of the wall bracket

7.2 Mount the wall brackets

The wall brackets are screwed in below on the rear of the system telephone, as shown in the picture. The example in
the picture shows an elmeg T500 extension. If you intend to attach more than one elmeg T500 extension, a wall
bracket needs to be attached to each extension.
System telephone
elmeg T500 extension
Wall bracket
Screws

7.3 Attach the system telephone to the wall

Dimensions and gaps
Caution
An extremely flat wall must be used for mounting. This will prevent the system telephone from moving.
It is important that you get the distances between the drill holes absolutely accurate.
(1) To do so, use the drilling template. You can use it for a telephone and an elmeg T500 extension.
(2) Drill the holes in the wall, as shown in the drawing below or the drilling template, and insert the dowels.
(3) Screw the screws into the dowels until the gap between the head of the screw and the wall is about 5 mm.
(4) Hang the system telephone on the screws' heads.
(5) Pull the system telephone a little to the right until it slots into the slit in the wall bracket, and then press it down.
System telephones elmeg S560 / elmeg S530
7 Wall mounting
13