Adjust The Base - BinTec elmeg S560 Manual

bintec elmeg GmbH
The picture shows the connector for S0.
The external S0 connector is connected to the »Line in« socket.
Another ISDN system telephone or ISDN telephone can be connected to the »Line out« socket. The maximum length
of the cable to the telephone here is 10 metres.
Up0 connector
The picture shows the connector for Up0.
The external Up0 connector is connected to the »Line in« socket.
Another ISDN system telephone or ISDN telephone can be connected to the »Line out« socket. The maximum length
of the cable to the telephone here is 10 metres.
5.1.2 Connect the receiver
Insert the RJ11 plug
Insert the RJ11 plug
beneath the cable retainers.

5.2 Adjust the base

You can adjust the telephone's gradient by putting the base into the rear or front retainer.
System telephones elmeg S560 / elmeg S530
into the RJ11 socket on the receiver.
into the RJ11 »Handset« socket on the underside of the receiver. Clamp the connector cord
5 System telephone installation
7