Sony LMD-A240 Operating Instructions Manual page 21

[Input Setting]
Submenu Setting
[Dual Link] Sets the dual link. Select from [422
YCbCr], [444 RGB], [444 YCbCr] or
[Off].
Enter the link A signal of the SDI dual
link signal to the SDI IN  connector
and the link B signal of the SDI dual
link signal to the SDI IN  connector.
Notes
When [Dual Link] is set to a setting

other than [Off], both LEDs of the
SDI 1 and SDI 2 buttons on the front
panel are lit.
When [Dual Link] is set to a setting

other than [Off], the SDI (3G/HD/
SD) signal of the single link cannot
be displayed while the SDI 1 or SDI 2
button on the front panel is pressed.
To display the signal of the single
link, be sure to set [Dual Link] to
[Off].
[SDI RGB Range] Sets the black level and white level for
the RGB format of SDI input.
[Limited]: [64] (black level) to [940]

[Full]: [0] (black level) to [1023]

[DVI RGB Range] Sets the black level and white level for
the RGB format of DVI input.
[Limited]: [16] (black level) to [235]

[Full]: [0] (black level) to [255] (white

[Anamorphic] Set to confirm the content using the
anamorphic lens.
Depending on the magnification of the
lens or the aspect ratio of the imager,
you can select from the following:
[Off]

[2.0X_4:3]

[2.0X_16:9]

[2.0X_17:9]

[1.3X_4:3]

[1.3X_16:9]

[1.3X_17:9]

(white level)
(white level)
(white level)
level)
Submenu Setting
[2.0X_4:3]
Note
When [Anamorphic] is set to a setting
other than [Off], the following
functions cannot be used:
[Side by Side]

[Wipe]

[Blending]

[Difference]

[Auto SDI Switch]

[Time Code]

[Closed Caption]

[AFD] When you perform screen scaling
automatically in the AFD flag setting on
the ANC data of the SDI signal, set to
[On]. When you do not perform scaling
automatically, set to [Off].
Stretched in a longitudinal
direction due to the
anamorphic lens.
2.39:1 Aspect display
With the AFD flag, provides
a full screen display of an
16:9 image within an SD 4:3
screen.
21
Adjustment Using the Menus