Sony LMD-A240 Operating Instructions Manual page 12

 The connection speed may be affected by the network
system. This unit does not guarantee the
communication speed or quality of 10BASE-T/
100BASE-TX.
 PARALLEL REMOTE connector (RJ-45, 8-pin)
Forms a parallel switch and controls the monitor
externally.
CAUTION
For safety, do not connect the connector for peripheral
device wiring that might have excessive voltage to this
port. Follow the instructions for this port.
Pin assignment
Pin number Functions
1 Designating [SDI1] input signal
2 Designating [SDI2] input signal
3 Designating [HDMI] input signal
4 Designating [Composite] input signal
5 GND
6 [WFM/ALM/Vector]
7 [Tally Green]
8 [Tally Red]
You can assign functions using the [Remote] menu (see
page 31).
Wiring required to use the Remote Control
Connect the function you want to use with a Remote
Control to the Ground (Pin 5).
 HDMI cable holder
Secures the HDMI cable (Ø7 mm or less).
Rotate to unlock the HDMI cable holder first, then
remove it.

(DC) input connector
Plug the DC power supply to this connector to provide
power to the monitor.
It runs on DC 12 V to 17 V.
12
Location and Function of Parts and Controls
Close
Cable
CAUTION
Be sure to connect to a power supply of the specified
voltage.
Pin assignment
Pin number Functions
1 – (GND)
2 NC
3 NC
4 + (DC 12 V to 17 V)
 AC IN socket
Connect the supplied AC power cord.