How To Extend The Talk Time; How To Call Into The System; How To Use The Keypad Access Code; How To The Card Access - PACH & COMPANY AeGIS 9100CR200 Installation And Programming Manual

HOW TO EXTEND THE
TALK TIME
HOW TO CALL INTO
THE SYSTEM.
HOW TO USE THE
KEYPAD ACCESS CODE
HOW TO USE THE
CARD ACCESS OR
RADIO TRANSMITTER
Pach and Company
AeGIS 9000 Series
The talk time can be programmed from 10 - 240 seconds. You will hear " One Long
Beep" ten seconds before the talk time expires. The tenant must press #
immediately to extend the talk time to another cycle. For example: if the talk time is set
for 30 seconds, pressing # will extend for another 30 seconds. You can continue
pressing the # to extend the talk time after the " One Long Beep".
The AeGIS 9000 Series will accept an incoming call from tenant and tenant can talk to
his or her visitor. This feature is not applicable if more than AeGIS 9000 Series are
connected on the same phone line, Function Code 27 must be set to RS-232 and
Function Code 07 must be enabled. The feature is very useful if for some reason you
are not available to answer the visitor call and you can call into the system later on.
Step 1 Call the system ( you must know the phone number) then you hear "One Short
Beep" if the call is connected.
Step 2 Press to talk to the visitor then press 9 (default setting to unlock relay 1 (door
*
1)) or 8 (default setting to unlock relay 2 (door 2)).
Step 1 Press * then the screen stops scrolling, if the screen is still scrolling, repeat this
step.
Step 2 Press a valid keypad access code and the door will unlock. If the keypad
access code is invalid the display shows
NOTE: If invalid codes are entered more than the number program on
Function Code 03, the display shows
the system will ignore further keypad access code entries for 90
seconds. If a telephone number is programmed on Function Code 09,
the display shows
ALARM ACTIVATED
Step 1 Place the card close enough to the red light emitting diode (LED) on the reader
or press the radio transmitter button
Step 2 The Card Reader will beep if the card is read properly and the green LED
blinks, the door will unlock if the code is valid or the display shows
NOTE: If invalid card access is used more than the number program on
Function Code 03, the display shows
If a telephone number is programmed on Function Code 09, the display shows
ALARM ACTIVATED
Chapter 4
SYSTEM'S OPERATION
and will call the number
programmed
and will call the number
programmed
Page 31