Set Time And Date - PACH & COMPANY AeGIS 9100CR200 Installation And Programming Manual

FUNCTION CODE
12

SET TIME AND DATE

• Time must be in military format.
• Time and Date must be set
according to the current local
time for event recording, time zone
and auto unlock schedules.
* T H E S Y S T E M W I L L N O T
C H A N G E T O
D AY L I G H T S AV I N G T I M E
A U T O M A T I C A L L Y .
FOLLOW THE STEP BELOW:
1 . Y O U M U S T B E O N S I T E
2. SELECT FUNCTION CODE 12
3. SET NEW TIME
4 . S E L E C T " 0 " F O R N O
DAYLIGHT SAVING.
5. CONTINUE ALL STEPS.
6. YOU DO NOT NEED TO BE
ON SITE TO SET THE DAY-
LIGHT SAVING THE FOLLOW-
ING YEAR. USE SOFTWARE
TO SYNCHRONOUS THE TIME.
Pach and Company
AeGIS 9000 Series
Step 1 Log on to programming mode (see section 3.1). The display shows
Step 2 Enter Function Code 12 then press # and the display shows
Step 3 Enter the HOUR (military format) then press # and enter the MINUTE then
press # the display shows
N E W
Step 4 Enter 1 for DAYLIGHT SAVING ZONE or 0 for NON DAYLIGHT SAVING
ZONE (DO NOT PRESS #), the display shows
Step 5 Enter
Step 6 Enter the current DATE, YEAR, and DAY OF WEEK (See table 3.1) then
press # the display shows
D
1
2
3
4
Step 7 Enter
Step 8 The display shows
Step 9 Select another Function Code to program different field from the table or
press * to exit the programming mode.
LOCAL PROGRAMMING
1 if the date is CORRECT and proceed to step 8
or 0 if it is NOT CORRECT, the display shows
DAY OF WEEK
MONDAY
TUESDAY
WEDNESDAY
THURSDAY
TABLE 3.1
1 if the date is CORRECT and proceed to step 8
or 0 if it is NOT CORRECT, return to step 5
Chapter 3
PROGRAMMING
* Your display may not look identical.
* Your display may not look identical.
MM= Month, DD= Date, YYYY=Year
D= Day of Week (see table 3.1)
D DAY OF WEEK
5 FRIDAY
6 SATURDAY
7 SUNDAY
Page 14