New Tenant Code; Modify Tenant Code - PACH & COMPANY AeGIS 9100CR200 Installation And Programming Manual

FUNCTION CODE
20

NEW TENANT CODE

consists of tenant code, name and
phone number
• Tenant Code (directory code) must
be a unique number. You may use
the apartment number, unit number ,
etc.
• The directory code can be 2, 3 or 4
digit. See Function Code 28 to set
Directory Digit.
• ALL the field must be
programmed.
• Name up to 12 characters.
• Phone number up to 11-digit.
21

MODIFY TENANT CODE

• To modify, you must know the
tenant code (directory code) that you
assigned on function code 20.
• If you do not know use Function
Code 78 to find the tenant code.
NOTE: Function Code 78 cannot be
used if you program a tenant with
NO NAME on Function Code 20.
Pach and Company
AeGIS 9000 Series
Step 1 Log on to programming mode (see section 3.1). The display shows
Step 2 Enter Function Code 20 then press # and the display shows
Step 3 Enter a new tenant code then press # (if the directory is already in used,
the display shows TENANT EXIST), the display shows
Step 4 Enter a tenant name up to 12 characters then press # after entering each
character and press ## after entering the last character (see figure 3.1
for keypad correlation), the display shows
Step 5 Enter a telephone number up to 11-digit then press enter, the display shows
Step 6 Select another Function Code to program different field from the table or
press * to exit the programming mode.
Step 1 Log on to programming mode (see section 3.1). The display shows
Step 2 Enter Function Code 21 then press # and the display shows
Step 3 Enter the tenant code to be modified then press # (if the tenant code does
not exist, the display shows TENANT NOT EXIST and proceed to step 4), the
display shows
Step 4 Enter a new tenant name (press * to clear the existing one) up to 12
characters then press # after entering each character and press ## after
entering the last character (see figure 3.1 for keypad correlation), the
display shows
Step 5 Enter a telephone number up to 11-digit then press enter, the display shows
Chapter 3
PROGRAMMING
LOCAL PROGRAMMING
Page 19