Master Code Mask; Open Door Beep; Enable Or Disable Pbx - PACH & COMPANY AeGIS 9100CR200 Installation And Programming Manual

FUNCTION CODE
40

MASTER CODE MASK

(Default setting is disabled)
WARNING !!!!!!!!
• Master Code cannot be recovered
if Master Code Mask is enabled. You
must request a new memory
(EEPROM) from Pach and Company
for nominal charge.
• The square RED button (retrieval
switch) on the board cannot recover
your existing master code.
41

OPEN DOOR BEEP

(Default setting is enabled)
• The system will beep if relay or
relay 1 (door 1) or relay 2 (door 2) is
unlocked.
42

ENABLE OR DISABLE PBX

(Default setting is disabled)
• This function must be enabled and
programmed to dial an outside line
from the PBX.
• If the function is enabled and the
PBX dial out number is programmed,
the system will provide a second
pause before it dials the phone
number
Pach and Company
AeGIS 9000 Series
Step 5 Select another Function Code to program different field from the table or
press * to exit the programming mode.
Step 1 Log on to programming mode (see section 3.1). The display shows
Step 2 Enter Function Code 40 then press # and the display shows
Step 3 Enter 0=NO or 1=YES then press # the display shows
Step 4 Select another Function Code to program different field from the table or
press * to exit the programming mode.
Step 1 Log on to programming mode (see section 3.1). The display shows
Step 2 Enter Function Code 41 then press # and the display shows
Step 3 Enter 0=NO or 1=YES then press # the display shows
Step 4 Select another Function Code to program different field from the table or
press * to exit the programming mode.
Step 1 Log on to programming mode (see section 3.1). The display shows
Step 2 Enter Function Code 42 then press # and the display shows
Step 3 Enter 0=NO or 1=YES then press #, the display shows
Chapter 3
PROGRAMMING
LOCAL PROGRAMMING
Page 26