Open Door 1 And Door 2 Number - PACH & COMPANY AeGIS 9100CR200 Installation And Programming Manual

FUNCTION CODE
• If the PBX is enabled, the system
will not dial a PBX extension.
43
OPEN DOOR 1 AND DOOR 2
NUMBER (REMOTE ACCESS
NUMBER) OR CCTV SWITCH
(Default setting is 9 to unlock
relay 1 (door 1) or 8 to unlock
relay 2 (door 2) or
CCTV is 6 to Open and 7 to close
the camera)
Pach and Company
AeGIS 9000 Series
Step 4 Enter the PBX number to get the outside line (up to 3-digit), then press #, the
display shows
Step 5 Select another Function Code to program different field from the table or
press * to exit the programming mode.
Step 1 Log on to programming mode (see section 3.1). The display shows
Step 2 Enter Function Code 43 then press # and the display shows
Step 3 Enter (0-9) then press #,
If relay 2 (door 2) is set for Mode 1
(door control), the display shows
proceed to step 4
if the number is already used the
display shows
return to step 3
Step 4 Enter (0-9) then press # the display shows
If relay 2 (door 2) is set for Mode 1
(door control), the display shows
proceed to step 5
Chapter 3
PROGRAMMING
LOCAL PROGRAMMING
if relay 2 is set for Mode 4 (CCTV
Switch), the display shows
proceed to step 4
if the number is already used the
display shows
return to step 3
if relay 2 is set for Mode 4 (CCTV
Switch), the display shows
Enter (0-9) then press # , the
display shows
proceed to step 5. If the number is
already used, the display shows
re-enter the number.
Page 27