Add Keypad Access Code And Card Number - PACH & COMPANY AeGIS 9100CR200 Installation And Programming Manual

FUNCTION CODE
30
ADD KEYPAD ACCESS CODE AND
CARD NUMBER (RADIO TRANS-
MITTER NUMBER)
• Add 4-digit keypad access code
and optional card number or radio
transmitter number (00001 - 65535).
• Name up to 16 characters.
• Up to three Time Zones Section
can be assigned (restricted or non-
restricted) for each code.
Pach and Company
AeGIS 9000 Series
Step 1 Log on to programming mode (see section 3.1). The display shows
Step 2 Enter Function Code 30 then press # and the display shows
Step 3 Enter 4-digit keypad access code then press # and the display shows
Step 4 Enter the card number or radio transmitter number (00001 - 65535) (leave
this field blank if no Card Reader installed on the system) then press #, the
display shows
if door 2 is set for mode 1 (door control). If door 2 is set other than mode 1,
proceed to step 6.
Step 5 Enter 1=Relay 1 (Door 1) , 2=Relay 2 (Door 2), 3=Both then press #, the
display shows
Step 6 Enter 1-3 then press #, the display shows
Step 7 Enter the Time Zone (s) programmed on Function Code 13 (0-9) then
press #, the display shows
Step 8 Enter 1=YES then press # and proceed to step 6 or 0=NO then press # and
the display shows
Step 9 Enter the name up to 12 characters then press #, the display shows
Step 10 Select another Function Code to program different field from the table or
press * to exit the programming mode.
Chapter 3
PROGRAMMING
LOCAL PROGRAMMING
Page 23