Advertisement
3. Wall and Magnet Installation
A. Wall-mount Installation
To install the PoE Ethernet Switch on the wall, simply
follow the following steps:
Step 1: There are 4 holes with 8mm diameter on
the wall; the distance between the 2 holes is
133mm and the line through them must keep
horizontal.
Step 2: Install a conductor pipe inside the board hole
and flush the edge of the conductor pipe with
the wall surface.
Step 3: Screw the bolts into the conductor pipe. The
HAC-1000 is between bolts and conductor pipe,
as shown below.
Z - w a v e
C o n tr o l
G a te w a
y
H A C -1 0
0 0 S e ri e
s
P W R
1 2 V D C
- 4 -
R es et
Advertisement
