Editing The Measurement Data Storage - wtw Multi 3430 Operating Manual

Multi 3430
Editing the data storage
Settings
ba75865e08 06/2010

4.10.3 Editing the measurement data storage

The contents of the manual or automatic measurement data storage
can be shown on the display.
Each of the measurement data storages has a function to erase the
entire contents.
The storage is edited in the menu, Storage & config / Data storage. To
open the Storage & config menu, press the <MENU/ENTER
the measured value display.
Open the manual or automatic storage directly with the <RCL> or
_
<RCL > key.
Note
The settings are explained here using the manual storage as an exam-
ple. The same settings and functions are available for the automatic
storage.
Menu item
Data storage /
Manual data storage /
Display
Data storage /
Manual data storage /
Copy to USB flash
drive
Data storage /
Manual data storage /
Output to RS232/USB
Data storage /
Manual data storage /
Erase
Setting/ Description
function
- Displays all measurement
datasets page by page.
Further options:
Scroll through the data-
sets with < >< >.
Output the displayed
dataset to the interface
with <PRT>.
Quit the display with
<ESC>.
- Outputs all stored measure-
ment data to a connected
USB flash drive
- Outputs all stored measure-
ment data to the interface
- Erases the entire manual
measurement data storage.
Note:
All calibration data remains
stored when this action is
performed.
Operation
_
> key in
89