Advertisement
Frame/Body Panels/Exhaust System
Handlebar Cover Removal/Installation
Handle Rear Cover Removal/Installation
(2) TURN SIGNAL
Remove the following parts:
WIRE CONNECTOR
- rear view mirror.
- four screws from the rear cover.
- tongue of the cover from the lug of the frame.
- tongue of the cover from the lug of the upper cover.
- rear cover.
Disconnect the turn signal/horn and starter switch wire con
nectors.
Connect the turn signal/horn and starter switch wire connec
tors.
Set the rear cover on the handlebar aligning the tongue of the
cover with the lug of the frame first, then align the tongue of
the cover with the lug of the upper cover securely.
Tighten the four screws.
Handlebar Front Cover Removal/Installation
Remove the four screws from the frame and upper cover.
Disconnect the both turn signal wire connectors.
Remove the front cover.
(6)
SCREW
Install the front cover in the reverse order of removal.
•
Handlebar Upper Cover Removal/Installation
Remove the two screws.
Disconnect the speedometer cable.
Disconnect the two 8P and engine stop switch wire connec
tors.
Remove the handlebar upper cover.
(1)
HANDLEBAR UPPER COVER
Install the handlebar upper cover in the reverse order of re
moval.
(2)
SCREW
(3)
SPEEDOMETER CABLE
Front Upper Cover Assembly
Remove the seven screws from the front inner cover, air
outlet and front inner fender A as shown.
Disconnect the claws of the under cover and both side cov
ers, then remove the front upper cover assembly.
(1)
FRONT UPPER COVER ASSEMBLY
Installation is the reverse order of removal.
NOTE
• At installation, align the claws of the front and side
covers securely.
II
2-3
Advertisement
