Arm Your System In Stay Mode - Interlogix zerowire User Manual

If your service provider has enabled the quick arm feature, you can simply touch the Away
key:
5.
6.
7.
Forced Arming Feature
Normally all zones must be secure before you can arm your security system.
For example, a home with a door detector on the front door. When forced arming is NOT
enabled, you would have to close the door to secure the sensor before being allowed to
arm the system. When force arming is enabled, you can arm your system with the door
opened, and the door will automatically be protected after it is fully closed as you leave.
If your service provider has enabled the "forced arming" feature, you will be able to arm
your security system even if pre-selected zones are not secure. The Ready Light will flash
green to indicate this feature is available. Press Status key to hear which zones are not
secure.
Check with your installer to confirm how Forced Arming has been set up for your
system:
Option 1: At the end of the exit delay, zones that are not secured will automatically be
bypassed. If they later become secured, the bypass will be automatically removed and
they will become part of the active security system until the system is disarmed.
Option 2: At the end of the exit delay:
• delay sensor types that are not secured will start an entry delay and go into alarm if a
valid PIN code is not entered,
• instant sensor types that are not secured will go into alarm immediately.

Arm your system in Stay Mode

Use Stay Mode when you are staying in the premises and you want the perimeter
protected whilst allowing you to move around inside without setting the alarm off. This
gives you peace of mind even when you are at home.
For example, Stay Mode is often used at night to arm zones around the perimeter of your
home and bypass all internal motion detectors. This will allow you to move around inside
your home without causing the system to sound an alarm. Perimeter detectors will still be
active to detect intruders. The security of your home in Stay mode is dependent on the
type and number of detectors you have installed and are active in Stay mode.
Normally all Stay Mode zones must be secure before you can arm in Stay Mode.
ZeroWire User Manual
READY STATUS
AWAY
EXIT DELAY BEEPS
Check ready key is green.
Check status key is green.
Select the Away Mode.
Leave the premises.
5