Table of Contents
Advertisement
ARMING YOUR SYSTEM IN THE "STAY" AND "NIGHT" MODES
STAY is used when the user is inside the premise and wants protection around the
perimeter.
•
1.
Close all protected doors and windows.
•
Ready light must be on or flashing when all protected zones and sensors
are secure. The system will not arm if the ready light is not on or flashing.
•
NOTE: If any zones are bypassed, a sensor in that zone can be violated
without affecting the ready light.
•
If the power light is off, you have no AC power. Restore power if possible.
If not, contact your installing company listed on page 1 of this booklet for
service.
•
2.
Enter your 4 or 6 digit user code.
•
If "Auto Bypass" is enabled, all interior zones will be bypassed if you do
not leave through a designated entry/exit door. Omit Step 3.
•
3.
Press [STAY].
•
The stay key will illuminate indicating that all interior zones are bypassed.
(All interior devices will bypass automatically, giving the user freedom of
movement within the interior area.) The away and night keys will flash
during the exit delay.
•
The bypass key will illuminate if any zone(s) are bypassed. If any zone(s)
have been bypassed previously by the user, the light(s) corresponding to
the bypassed zone(s) will illuminate, alerting the user that a zone(s) may
be unprotected and can be faulted without an alarm.
To toggle between the STAY and NIGHT mode, double press the key
4.
corresponding to the mode you desire.
To upgrade from the STAY or NIGHT mode to the AWAY mode, double press
5.
[AWAY].
Note: Once the AWAY mode is activated, the system must be
disarmed to revert to the STAY or NIGHT mode.
USING THE QUICK ARM (Optional, see page 1)
The Quick Arm feature may be used if it is enabled. Quick Arm will allow the user to
arm the security system in the AWAY, STAY, or NIGHT mode by pressing the
corresponding key twice. This feature is used for ARMING ONLY, and will not disarm
the security system. This is ideal for a maid or baby sitter, etc.
CHANGING MODES WHILE SYSTEM IS ARMED (Optional, see page 1)
Double pressing the [AWAY], [STAY], or [NIGHT] key will change to the corresponding
mode. Once the AWAY mode is entered, the system must be disarmed to change
modes.
LED Keypad
Advertisement
Table of Contents
