UltraConnect App
Introduction
UltraConnect is a smartphone app that allows you to:
•
Check the status of your system
•
Arm and Disarm partitions
•
Bypass zones
•
Set up users
•
Operate Z-Wave devices
•
Set up system and Z-Wave features (the scope depends on your assigned user type:
Standard or Master)
•
Add a camera
Web Access Code
This code should be written on the rear of this manual. It permits remote access from the
UltraConnect app. When it is set to 00000000 the app is prevented from connecting.
Example: Listen to the Web Access Code or change it to a new one.
1.
YOUR 4 TO 8 DIGIT MASTER CODE
2.
3.
WEB ACCESS CODE
4.
5.
8 DIGIT CODE
6.
MENU
User Name and PIN
The UltraConnect app requires a valid username and PIN code to function. A default user
should be written on the rear of this manual, or refer to "Add a Username" on page 10. The
menus available are dependent on the permissions for the user entered.
14
MENU
9
ENTER
9
ENTER
MENU
MENU
Select Zone Configuration.
Select Web Access Code.
Web Access Code will be flashed on the key pad.
Enter a new 8 digit Web Access Code, or skip.
Exit from Advanced system configuration.
ZeroWire User Manual