How To Install - Orion opm-4260 User Manual

2. How to Install

y
Install this set only at a location where adequate ventilation is available.
How to assemble handles
1. Product is packed in a box as shown in Figure 1.
2. Please carefully remove the Packing Bag with a knife or a pair of scissors.
※ Please check front and rear side before you cut the bag to prevent any damages
on panel or set.
Packing Bag
[Figure 1]
3. Please assemble handles with the bolts that are in the accessory box to the
rear side as shown in the figure.
handles
[Figure 3]
Panel protection
[Figure 2]
[Figure 4]
5 5
How to move MPDP
1. 2 people hold each handle on product's back side.
handles
2. 2 people transfer the product with holding the handle and the front part at
the same time.
Panel protection
※Attention : Do not remove the panel protection pad until a set is completely installed on a stand or a wall hanger.
Please carefully remove Panel protection pad to prevent any damages on the product .
※Do not incline the panel forward.
The edge or bottom of the panel can be damaged.
When you need to lay a set down on the floor, please use shock-
absorbing pads or rug beneath the set.
Attention
PANEL
PANEL
PANEL
6 6
Infinitely expandable
Panel protection
PANEL