Ultimaker UM2 Assembly Manual page 8

10. Turn the Front pannel around
so the T-slots are visible. Now
clean the back of the front pannel
with acetone or alcohol, so the
LED strip will stick better.
11. Install the LED strip in
the machine. Remove the
stickytape from the first LED
strip and start at the bottom
right of the plate. Then move
up wards until you reacht the
top right corner.
push between each LED
13. Make extra sure to
stick the LED strip very
firmly on the housing.
Otherwise, it can deat-
tach at a later stage!
12. The second part of the LED strip
goes on the top of the front plate,
start at the right and go to the top
left corner.
8