Xy-Motors - Ultimaker UM2 Assembly Manual

B3. XY-motoren
28. Secure the two pulleys
with the 5mm hole on the
motors with the M4x4 slugs.
the end of the pulley has to
be flush with the axle. make
sure you screw them tight
27.
These are the nessacery parts to
secure the motors. Make sure that you
take the two with the shorter axels
29. The wide side of the pulley
has to face away from the motor
30.
Attatch the small timingbelt
around the pulley. Next make sure
the motor wires are guided around
the little hook at the bottom of the
motorspacer. do this before you
attach the spacer to the frame of
the machine.
18