Xy-Assen - Ultimaker UM2 Assembly Manual

7.
B2.

XY-Assen

8mm holes) and in the double 8mm pulley setscrews:
8x M4x4mm. Doing this now is much easier than later
on in the build.
8. Slide one of the short axes through the
hole at the front left of the machine.
Screw a setscrews in all the 8 axes pulleys (with the
9. Then slide a 10 mm spacer around it and
then a pulley. The wide side of the pulley
has to face towards the frame.
10. Next is the assembled slider block.
This is followed by a further pulley, and
finally again a 10 mm spacer. Check if its
correct using the photo
13