Anti-Skating Force Adjustment - Pro-Ject Audio Systems 2 xperience sb s Instructions For Use Manual

Once the arm is balanced correctly return it to the rest. Hold the counterweight (5) without moving it and gently
revolve the downforce scale ring (5a) until the zero is in vertical position. Check whether the arm still balances
out.
Rotate the counterweight counter clockwise (seen from the front) to adjust the downforce according to the
cartridge manufacturer's recommendations. One mark on the scale represents 1 mN (= 0,1g / 0,1 Pond) of
downforce.

Anti-skating force adjustment

The anti-skating mechanism is shipped partially disassembled to avoid damage during transport. For correct
installation, please follow the steps below.
Step 1:
Prepare anti-skating sliding mechanism from the accessories bag.
The anti-skating sliding mechanism is supplied with a pre-mounted anti-skating weight and thread for
mounting on the tonearm.
Step 2:
Put the eye of the anti-skating thread around the hole for the HOOK SCREW and screw the HOOK SCREW
into the tonearm through the eye of the anti-skating thread as shown in the illustration below.
Step 3:
Put the anti-skating sliding mechanism on the end of the anti-skating support rod. The anti-skating thread
should fit into the groove in the tonearm.
Be careful when handing the anti-skating thread in order to avoid damaging it.
5
© Pro-Ject Audio Systems · Pro-Ject 2Xperience SB S · Revision 2015.07.30