Access Point Setup; Basic Configuration; Customized Configuration - ADB M2123 User Manual

ADB Wi-Fi Remote Control

8. Access Point setup

This chapter describes the setup for the D-Link DWL-2000AP Access Point. Other
Access Points may work but are not supported by ADB.

8.1. Basic configuration

The Basic Configuration does not require any configuration of the Access Point itself.
It is the simplest set-up, but it has no privacy / security WEP
Supply the Access Point with 230 V.
Connect the Access Point with an Ethernet cable (standard or cross-link) to an ISIS
desk, or to an Ethernet Switch on your lighting network. Configuration is done.
SECURITY WARNING: This basic configuration has no privacy / security (WEP)!

8.2. Customized configuration

A Customized Configuration requires a PC with a Windows operating system. The
set-up procedure is for an Access Point set to its original factory default settings.
This includes IP address, password ...
6
Wired Equivalent Privacy; a security protocol for wireless local area networks.
7
This Access Point has a Reset button to restore its original factory default settings; refer to the
D-Link DWL-2000AP User Manual.
Manual – page 12
Issue: 1.03
D-Link DWL-2000AP
www.adblighting.com
6
.
®
7