ADB Remote Control Programming Manual

Programming Your Remote Control
Programming with Automatic Search:
• Start with the TV turned on.
• Press & release the TV button .
• Press & hold the RCU SETUP button
 until the TV button  blinks twice.
• Enter 9-9-1. The TV button  will
blink twice. (9-9-1 should NOT appear
on the TV screen)
• Aim the remote at the TV, then Press
& release the POWER button .
• Press & release the CH+ or CH-
(Channel) button continuously until
the TV turns off.
• Press the POWER button  to turn
the TV back on.
• Press the RCU SETUP button  to
store the code for the TV. The TV
button  will blink twice.
Notes: If either the CH (Channel) or VOL
(Volume) buttons don't function correctly you
TV Button

STB Button

POWER

Button
RCU SETUP

Button
CH (Channel)

+/- Button
Mount Horeb Office 437-5551
Dodgeville Office 930-9985
Tech Support: 1-800-843-5827
may need to go through the steps above again
until the remote finds another code for the TV.
By default the TV channel should be set to
Channel 3. Please make a note if the MHTC
technician states otherwise.

Volume Lock:

Control the volume on your TV regardless
of what "device" is selected (TV, STB, etc):
• Press & release the TV button .
• Press & hold the RCU SETUP button
 until the TV button  blinks twice.
• Enter 9-9-3.
• Press & release the TV button . The
TV button will blink twice.
Programming One Touch Power:
Control the power to the TV without
turning off the Set-Top Box. (2 Steps)
Step 1 - Clearing One-Touch Power:
• Press & release the STB button .
• Press & hold the RCU SETUP button
 until the STB button  blinks twice.
• Enter 9-8-0. The STB button  will
blink several times.
Step 2 - Setting One-Touch Power:
• Press & release the STB button .
• Press & hold the RCU SETUP button
 until the STB button  blinks twice.
• Enter 9-9-5.
• Press & release the POWER button .
• Press & release the TV button .
• Press & release the POWER button .
• Press & release the STB Button .
• Press & hold the RCU SETUP button
 until the STB button  blinks twice.
• Press POWER  to test if successful
(TV should turn off while Set-top box
remains on); if not you must repeat
both Step 1 and Step 2.
The Learning Feature:
Transfer functions from a FACTORY
remote control to the MHTC remote.
These instructions are available on our
website, www.mhtc.net.