Cembre PO7000 Operation And Maintenance Manual page 5

01 02 03 04 05 06 07 08 09 10 11
H
F
H
46 45 44 43
78
77
F-F
47 48 49 80
12 13
E-E
42 41 40 39
58
57
55
54
53
52
51
50
2. INSTRUCTIONS FOR USE
14 15 16
2.1) Operation
– Place the pump on a fl at surface, with the whole of the base resting on the ground. This
will provide stability for the pump during operation.
– Before operating the pump, ensure that the coupler on the head is securely fi tted to the
coupler on the hose.
– Open the latch (13) to release the spring-loaded pedal (46) (see Fig 3a). Commence
operation by pumping the pedal (23).
– Continue pumping (see Fig. 3b) until the operation is complete (dies touching for the
crimping head and cable cut through for the cutting head).
Note: for crimping heads, it is recommended to continue pumping until the maximum
pressure valve is actived and a "click" is heard.
– To release the oil pressure and reset the head to the rest position, depress the pedal
(63) until the ram fully retracts (see Fig. 3c)
2.2) Storage
After completion of the work store the pump in the steel case with the pressure fully
released.
– Depress pedal (23) and lock in position with the latch (13).
38 37
– Fully release the oil pressure by depressing the pressure release pedal (63).
– Coil the hose, in wide loops around the pump.
– Place the pump in the plastic case.
3. WARNING
The pump is robust and requires very little daily maintenance.
Compliance with the following points, should help to maintain the optimum performance
of the pump:
3.1) Accurate cleaning
Dust, sand and dirt are a danger for any hydraulic device.
Every day, after use, the tool must be cleaned with a clean cloth, taking care to remove
any residue, especially close to pivots and moveable parts.
3.2) Storage
When not in use, the tool should be stored and transported in the plastic case, to prevent
damage.
Plastic case: VAL P 21; size: 820x430x290 mm (32.3x16.9x11.4 in.); weight: 6,7 Kg (14.8 lbs).
3.3) Flexible hose
The fl exible hose is designed for high-pressure operation and should not be tightly bent,
knotted, kinked or squashed.
Take care when storing the pump in the plastic case, the hose should be coiled in wide loops.
31 4
(Ref. to Fig. 3)
(Ref. to Fig. 4)
ENGLISH