Cocraft PRO IT1050-M Instruction Manual page 5

e) Maintenance of electrical hand tools. Check if something is incorrectly set,
if movable parts are getting jammed, or parts are broken or something else
that might cause dysfunction to the electrical hand tool. If something is
damaged it must be repaired before use. Many accidents are caused by poorly
maintained electrical hand tools.
f) Keep the tools sharp and clean. Properly maintained cutting tools with sharp
blades are less disposed to getting jammed and are easier to control.
g) Use the electrical hand tool, accessories and such according to
the instructions and in a way suitable for the type of electrical hand
tool used. Using the electrical hand tool for work other than suitable work could
result in a dangerous situation.
5) Service
a) Repairs and service should only be performed by qualified persons, and only
with original spare parts. This guarantees the safety of the electrical hand tool.
Specific Safety Requirements for Hammer Drills
• Always wear hearing protection when hammer drilling. Exposure to excessive
noise can cause hearing loss.
• Always use an auxiliary handle if one is supplied. Loss of control over
the power tool can cause personal injury.
• Hold the power tool by its insulated gripping surfaces when performing
an operation where the cutting accessory may contact hidden wiring or
the power tool's own mains lead. Cutting accessories which contact "live" wires
may make exposed metal parts of the power tool "live" and could give the operator
an electric shock.
Vibration
• The measurement of the vibration emission level declared in this instruction manual
has been carried out in accordance with a standardised test method described in
EN 60745 and can be used for comparing one power tool with another.
• The measurement method may also be used for a preliminary assessment of vibra-
tion exposure.
• The declared vibration emission level applies when the power tool is used in ac-
cordance with this instruction manual. If however, the power tool is used for other
purposes and with other accessories or has not been properly maintained, the
vibration emission level could increase significantly over the total working period.
• For an exact assessment of the vibration exposure, the times when the tool is swit-
ched off or running idle should also be taken into account. This significantly reduces
the vibration exposure over the total working period. Decide upon safety measures to
protect the operator from the effects of vibration during all types of use.
5