Warranty Information; Additional Equipment - PowerBox Systems 40/16 Operating Instruction

POWER BOX 40/16
5.

Warranty information

Each Power Box 40/16 has had to pass through several tests during its production
phase. We put special emphasis on producing a very high quality-product. This fact
enables us to give you a guarantee on our Dual-power–Control of 24 months from
the day of your purchase. This means that we will repair proven any faults in the
product during this period. We may decide to exchange the switch if a repair is not
possible.
The dated receipt you receive when buying the unit is the proof for the duration of
the warranty. A repair will not increase the life of the warranty.
Should you damage the switch e.g. by connecting it to the wrong poles, by
exceeding the voltage limit, which is described in the specifications, you will forfeit
your warranty. This also applies should the unit experience any damage due to
heavy wear or excessive vibrations. Further demands on damages caused by the
Dual-Power-Control are also excluded. Any demands for damages caused by the
Power Box whilst using it are also excluded.
If you return your Dual-Power-Control, please ensure that you pay all the
necessary forwarding expenses. We cannot accept any non-prepaid packages. We
do no take on any liability for damages due to transport damage or any loss of your
package. In case of a warranty claim please send the switch together with your
voucher to following address. Please also give us a brief description of the
malfunction noted.
6.

Additional equipment

As a connection from battery to the Dual-Power-Control we recommend that you
use our special High-Current switches at all times. These specially produced
switches are adjusted to suit our POWER BOX 40/16. They can manage the higher
current required far better than any other switch now being used for flight sets in
modelling.
Our High-Current-switches offer real security. This will provide a safe connection
by using 8 independent contacts for switching the "+"-pole. A green LED is
integrated into our each high-current switch. This bright LED shows you the
momentary situation of the switch.
Furthermore an extra feature is a plug-in socket for recharging built into the switch
housing which can handle a recharging voltage of up to 2 A. But we want to point
out that fast charging via this plug-in isn't possible with some battery chargers. In
this case we recommend that you rapid charge directly via an accumulator-plug. By
- 7 -