Canon LBP5300 User Manual page 403

Cause 2
Remedy
Cause 3
Remedy
Residual images appear on non-printed areas.
Cause 1
Remedy
Cause 2
Remedy
Cause 3
7
Remedy
Cause 4
Remedy
The overall print result is faint.
Cause 1
Remedy
Cause 2
Remedy
7-38 Print Quality Problems
Downloaded from ManualsPrinter.com Manuals
Paper is damp since the paper has been stored in unsuitable condition.
Replace the paper with new one and print again. (See "Paper Requirements,"
on p. 3-2)
The drum in any of the toner cartridges has deteriorated.
Replace the toner cartridge with a new one. (See "Replacing Toner Cartridges,"
on p. 6-2)
Printing paper is inappropriate.
Change the paper and print again. (See "Paper Requirements," on p. 3-2)
Paper with a glossy surface was printed.
Set [Special Print Mode] to [Special Settings 3] in the printer driver. If this solves
the problem, set [Special Print Mode] to [Off].
In order to specify the setting for [Special Print Mode], display the [Advanced
Settings] dialog box by clicking [Finishing Details] in the [Finishing] sheet, and
then clicking [Advanced Settings] in the [Finishing Details] dialog box.
Residual images appear depending on the printer status.
Set [Special Print Mode] to [Special Settings 8] in the printer driver. If this solves
the problem, set [Special Print Mode] to [Off].
In order to specify the setting for [Special Print Mode], display the [Advanced
Settings] dialog box by clicking [Finishing Details] in the [Finishing] sheet, and
then clicking [Advanced Settings] in the [Finishing Details] dialog box.
The drum in any of the toner cartridges has deteriorated.
Replace the toner cartridge with a new one. (See "Replacing Toner Cartridges,"
on p. 6-2)
The setting for [Toner Density] is not appropriate.
Drag the [Toner Density] slider in the printer driver toward [Dark].
In order to specify the setting for [Toner Density], display the [Custom Settings]
dialog box by clicking [Settings] in the [Quality] sheet.
[Toner Save] is enabled.
Clear the [Toner Save] check box in the printer driver.
In order to specify the setting for [Toner Save], display the [Custom Settings]
dialog box by clicking [Settings] in the [Quality] sheet.