Safety Notice - TAMUZ KVM 9050W Operation Manual

Safety Notice

Safety Notice
• The place chosen to put the unit into service should be free of danger to individuals when the unit is extending or in its
extended position.
• When utilizing a motorized version of the unit it is not allowed to interfere with the moving portion during automatic
extension or retraction.
• The user is forbidden to open up the unit; it contains no user serviceable or adjustable parts.
• Installation, upgrading, new adjustments, changes or repairs may only be carried out by an authorized technician.
• The electrical installation of the relevant built-in frame must meet the requirements of IEC-restrictions and national
regulations.
• Pay close attention that the electrical current required by the unit is the same as the electrical current supplied to it.
• A power outlet and an external power cut-off switch must be in close proximity to the unit and easily accessible.
• Use only the included power cable and a correctly grounded power outlet.
• Avoid a power connection though a multi-outlet when other power consuming devices are connected. Do not use an
extension cable.
• Any disconnection of the grounding cable inside or outside of the unit or loosening of the grounding cable is inadmissible
and can lead to a dangerous situation.
• All plugs on the connecting cables must be screwed or bolted down to the housing.
• Discontinuation of electrical current is accomplished by pulling the power plug or switching off the external power switch.
• Assume that it is not possible to operate the unit in a danger free manner if visible damage is present or if the unit no
longer works. In this case the unit should be turned off and disconnected from the power supply and protected against
further unintentional use.
• Use only the included cables or shielded data cables with double-sided shielding connector.
• Do not install the unit in an area with direct sunlight or in close proximity to heat sources or damp areas. Ensure that the
unit receives adequate air circulation.
• Ensure that no cables, especially no power cables, are located in traffic areas such that persons might trip or get
entangled in them.
• Transporting of the unit should only take place in the original packaging. Only this way is the unit secure from being
bumped or hit.
• Before the unit is put into operation it must be ensured that the operational-environment requirements have been net.
• Remove the power supply before cleaning. If heavy soiling exists, the unit can be cleaned using a damp cloth with a mild
cleaning agent. Ensure that no water gets into the inside of the unit through openings. The inside of the unit may only be
cleaned by an authorized technician.
© 03.14 TAMUZ Broadcast
OSPREY G3 Series
Digital Broadcast Monitor Page - 37 -