Audio; Pip/Pbp - TAMUZ KVM 9050W Operation Manual

OSD Menu
Menu Item
Swap
(this item shows in PIP
mode)

Audio

Within this Top-menu the general settings to arrange the audio are done.
Menu item
Volume
Headphone Volume
Audio Channel
Audio Level Meter

PIP/PBP

Within this Top-menu the settings to display signals singularly or simultaneously on screen are done.
Menu item
Layout
Main Window Source
© 03.14 TAMUZ Broadcast
Setting
Note: Use the FACTORY RESET in any case the monitor works not as expected.
Setting
0-100
0-100
CH1&CH2
CH3&CH4
CH5&CH6
CH7&CH8
ON
OFF
Setting
Main Window
PIP
PBP
Video
S-Video
YPbPr
SDI1
SDI2
VGA
HDMI
In PIP and PBP, press RIGHT button to switch the signal
pictures between the two windows (main picture and sub
picture)
Speaker volume adjustment
Headphone volume adjustment
SDI embedded audio CH1 & CH2
SDI embedded audio CH3 & CH4
SDI embedded audio CH5 & CH6
SDI embedded audio CH7 & CH8
Turn on/off audio level meter display
Display only a single signal picture on screen
Display two signals pictures simultaneously on
screen, the sub picture in the main picture.
Display two signals pictures side-by-side simulta-
neously on screen, the sub picture at the right side
of the main picture.
Note: In PIP/PBP mode, one signal is SDI, the other
signal is any of other input signals. The two pictu-
res should be different signal formats.
Main Window select signal input between Video/
S-Video/ Component/ SDI1/SDI2/VGA/ HDMI
(Note: Component is compatible with RGB, YCb-
Cr, YPbPr)
Digital Broadcast Monitor
OSPREY G3 Series
Description
Description
Description
Page - 29 -