Remote Control
Remote Control
Hardware connection
Connect the monitor's RS-232 serial port to the computer to remote control the monitor by universal seri-
al communication software.
Software Configuration
Start communication software, configure the serial communication parameters, sending communications
test command, if the return value is
Serial port settings:
• Baud Rate: 19200
• Parity: Non
• ?Data bits: 8
• ?Stop bit: 1
• ?Flow Control: None
Communications test
Communications test command
BE EF 01 05 00 D1 FA 01 02 00 00 00 1E BE EF 01 04 00 37 3D 01 02 00 01
© 03.14 TAMUZ Broadcast
correct, you can send control command.
Return value
OSPREY G3 Series
Return value is cor-
rect, the communi-
cation setup is nor-
mal
Digital Broadcast Monitor
Description
Page - 32 -