Table of Contents
Advertisement
PCAN-Dongle (ISO) – User Manual
3
Software Setup
This chapter describes the installation of the delivered software.
You get to know more about its use in the following chapter 4.
3.1
Windows Operating Systems
Under Windows a driver is needed that can access the PCAN-
Dongle and that provides the interface for Windows software.
Beside the mentioned device driver the CAN monitor PCAN-View
for Windows can also set up.
Note: The following instructions are valid only for Windows
2000 and Windows XP. If you use the operating systems
Windows 98 SE or Windows ME, please contact the customer
support (address: see page 2).
Do the following to setup the driver and, if applicable, additional
software:
1.
Please make sure that you are logged in as user with
administrator privileges (not needed for normal use of the
PCAN-Dongle later on).
2.
Insert the supplied CD-ROM into the PC. Usually a
navigation program appears a few moments later. If not,
start the file Intro.exe from the root directory of the CD-
ROM.
3.
Navigate through the menus to the driver installation for the
PCAN-Dongle (English > Drivers > PCAN-Dongle). Click on
Install now afterwards. The setup program for the driver is
executed.
4.
Follow the instructions of the setup program.
10
Advertisement
Table of Contents
